Subaru Crosstrek Service Manual: Dtc u0428 invalid data received from steering angle sensor module
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0428 INVALID DATA RECEIVED FROM STEERING ANGLE SENSOR MODULE
NOTE:
Refer to “LAN SYSTEM” for diagnostic procedure. Basic Diagnostic Procedure">
Dtc u0100 lost communication with ecm/pcm a
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM” ...
Dtc u0101 lost communication with tcm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMNOTE:Refer to “LAN SYSTEM” for diagnostic proc ...
Other materials:
Wheel alignment Inspection
REAR SUSPENSION > Wheel AlignmentINSPECTIONNOTE:Measure and adjust the front and rear wheel alignment at a time. Refer to “Wheel Alignment” in “FRONT SUSPENSION” section for measurement or adjustment of wheel alignment.• Inspection: Wheel Alignment > INSPECTION&q ...
Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Power Steering Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the power steering control module.(1) Disconnect the connector of the power steering control module.(2) Remove the nuts, and remove the power steering ...
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...
