Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b1675 satellite safing sensor failure

AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code

DTC B1675 SATELLITE SAFING SENSOR FAILURE

Diagnosis start condition:

Ignition voltage is 10 V to 16 V.

DTC detecting condition:

Satellite safing sensor is faulty.

Airbag control module is faulty.

CAUTION:

Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">

STEPCHECKYESNO

1.REPLACE SATELLITE SAFING SENSOR.

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Replace the satellite safing sensor with a genuine sensor. Satellite Safing Sensor > REMOVAL">

Does the warning light go off?

Finish the diagnosis.

Replace the airbag control module. Airbag Control Module > REMOVAL">

Dtc b1660 passenger s airbag on indicator failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1660 PASSENGER’S AIRBAG ON INDICATOR FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condi ...

Dtc b1676 lost communication with satellite safing sensor
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1676 LOST COMMUNICATION WITH SATELLITE SAFING SENSORNOTE:For details on DTC B1676, refer to DTC B1677. Diagnostic Chart with Tr ...

Other materials:

Dtc b14e9 intake door actuator circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E9 INTAKE DOOR ACTUATOR CIRCUIT OPENDTC detecting condition:Intake door actuator potentiometer circuit is open.Trouble symptom:FRESH/RECIRC does not operate.Wiring diagram:Air conditioning system ...

Installation
ENTERTAINMENT > GPS AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” ...

Safety precautions
WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury. For models with HID low beam headlights, observe the following precautions. Not doing so carries the ...

© 2016-2026 Copyright www.sucross.com