HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN
DTC detecting condition:
Evaporator sensor circuit is open.
Trouble symptom:
Evaporator temperature is falsely recognized as low, and the compartment temperature is adjusted.
Wiring diagram:
Air conditioning system Air Conditioning System > WIRING DIAGRAM">

| STEP | CHECK | YES | NO |
1.CHECK CONNECTOR.
1) Check the condition of connector connection.
2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is B1434 displayed?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 2.
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK EVAPORATOR SENSOR.
1) Disconnect the evaporator sensor.
2) Short the evaporator sensor connector (B88).
3) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is B1435 displayed?
Replace the evaporator sensor. Evaporator > REMOVAL">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 3.
3.CHECK HARNESS.
1) Restore the temporary shorted lines made in step 2.
2) Turn the ignition switch to ON.
3) Using the tester, measure the voltage between terminals.
Connector & terminal
(B88) No. 2 (+) — No. 1 (−):
Is the voltage 4.5 — 5.0 V?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1434 EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN">Go to Step 4.
Repair or replace the open circuit of harness.
4.CHECK HARNESS (OPEN CIRCUIT).
1) Disconnect the connector from the A/C control panel.
2) Using a tester, check continuity between terminals.
Connector & terminal
(B88) No. 1 — (i88) No. 14:
(B88) No. 2 — (i88) No. 18:
Is there continuity?
Replace the A/C control panel. Control Panel > REMOVAL">
Repair or replace the open circuit of harness.
Dtc b1433 ambient temperature sensor circuit short-circuit (air-conditioner)
Dtc b1435 evaporator temperature sensor circuit short-circuitDtc c1811 system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1811 SYSTEMDTC detecting condition:ABS and VDC long time sequential controlTrouble symptom:• ABS does not operate.• VDC does not operate.• EBD may not operate.• Hill ...
Dtc u0155 lost communication with instrument panel cluster (ipc) control module
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDetected when CAN data from meter does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Di ...
Adjustment
WIPER AND WASHER SYSTEMS > Rear Wiper ArmADJUSTMENT1. Operate the rear wiper once.2. Align the blade assembly - rear wipe with the marking on the glass.3. If the wiper blade is not aligned with the point mark, perform the removal of the rear wiper to align with the marking. Rear Wiper Arm > R ...