Installation
AdjustmentInspection
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitINSPECTION1. Disconnect the connector of the turn signal & hazard unit.2. Measure the voltage between the turn signal & hazard unit connector and the chassis ground.Preparation tool:Circuit testerTerminal No.Inspection conditionsS ...
Inspection
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSPECTION1. Moving the front tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the hub unit bearing.2. Inspect ...
Adjustment
DIFFERENTIALS > Rear Differential (T-type)ADJUSTMENT1. SIDE GEAR BACKLASHAdjust the side gear backlash. Rear Differential (T-type) > ASSEMBLY">2. HYPOID DRIVEN GEAR BACKLASHAdjust hypoid driven gear backlash. Rear Differential (T-type) > ASSEMBLY">3. TOOTH CONTACT BETWEEN ...