Subaru Crosstrek Service Manual: Combination switch (wiper)

Wiper and washer systems

...

Inspection

WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)INSPECTION1. INSPECTION OF SWITCH UNIT1. Operate the switches to check the continuity between terminals. Switch positionTerminal No.StandardFron ...

Other materials:

Installation
GLASS/WINDOWS/MIRRORS > Rear Quarter GlassINSTALLATION1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(1)10 mm (0.39 in)(2)8 mm (0.31 in)(3)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rear quarter and body using the same procedure ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpINSTALLATION1. Install the O-ring.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. Install the plate and the oil pump.NOTE:Apply CVTF to the bolt.Tightening torque:8.5 N·m (0.9 kgf-m, 6.3 ft-lb)3. Install the oil pump chai ...

Removal
EXTERIOR/INTERIOR TRIM > Rear BumperREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...