CRUISE CONTROL SYSTEM > Combination Meter
NOTE
For the operation procedures for combination meter, refer to “INSTRUMENTATION/DRIVER INFO” section. Combination Meter">
Clutch switch Note
Control unit NoteAssembly
EXHAUST(H4DO) > Front Exhaust PipeASSEMBLY1. Install each cover to the front exhaust pipe.Tightening torque:13 N·m (1.3 kgf-m, 9.6 ft-lb)(A)Front exhaust pipe upper cover(E)Front catalytic converter lower cover LH(H)Front exhaust pipe side cover LH (rear)(B)Front catalytic converter upper ...
Installation
LIGHTING SYSTEM > Front Fog Light AssemblyINSTALLATIONCAUTION:Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).1. Install each part in the reverse order of removal.Tightening torque:Fog light assembly - front: 7.5 N·m (0.76 ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...