1) 0.02 - 0.11 in (0.5 - 2.7 mm)
Turn the ignition switch to the "LOCK"/ "OFF" position and firmly depress the brake pedal several times. Lightly pull the brake pedal up with one finger to check the free play with a force of less than 2 lbf (10 N, 1 kgf).
If the free play is not within proper specification, contact your SUBARU dealer.
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Inspection
FRONT SUSPENSION > Front StrutINSPECTIONCheck the removed part for wear, damage and cracks, and then repair or replace it if defective.1. STRUT1. Check for oil leaks.2. Move the piston rod up and down to check that it operates smoothly without any hitch.3. Check the piston rod runout.Preparation ...
Installation
EXHAUST(H4DO) > Front Exhaust PipeINSTALLATION1. Set the front exhaust pip and center exhaust pipe to the vehicle, and temporally tighten the nuts which secure the front exhaust pipe to cylinder head.NOTE:Use a new gasket.2. Install the bolts, springs, and nuts which secure the rear exhaust pipe ...