Subaru Crosstrek Service Manual: Caution

Subaru Crosstrek Service Manual / Emission control (aux. Emission control devices)(h4do) / General description / Caution

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General Description

CAUTION

• Prior to starting work, pay special attention to the following:

1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

2. Protect the vehicle using a seat cover, fender cover, etc.

3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.

• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

• Keep the removed parts in order and protect them from dust and dirt.

• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.

• Bolts, nuts and washers should be replaced with new parts as required.

• Be sure to tighten the fasteners including bolts and nuts to the specified torque.

Preparation tool

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current. ...

Other materials:

Removal
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Disconnect the connector (A).3. Remove the nut (B) securing accelerator pedal assembly, and remove the accelerator pedal assembly. ...

Component
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > General DescriptionCOMPONENT1. HEATER AND COOLING UNIT• Manual A/C model(1)Pipe - inlet(11)Shutter - defroster(21)Packing - evaporator core(2)Pipe - outlet(12)Shutter - vent(22)Pipe - evaporator core(3)Clamp - pipe(13)Shutter - air mix RH(23)Case - ...

PIN Code Access (models with "keyless access with push-button start system")
Rear lock button While all doors (including the rear gate) are locked, you can unlock the doors (including the rear gate) without a key by pressing the rear lock button. NOTE PIN Code Access will be helpful if the key is accidentally left in the vehicle. It is recommended that a 5-d ...