Subaru Crosstrek Service Manual: Assembly
DRIVE SHAFT SYSTEM > Rear Hub Unit Bearing
ASSEMBLY
1. Install the rear hub unit bearing to the ST securely.
Preparation tool:
ST: HUB STAND (927080000)
(1) | Rear hub unit bearing |
2. Using a press, press new hub bolts (b) until their seating surfaces contact the rear hub unit bearing (a).
NOTE:
Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting.
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doi ...
Other materials:
Inspection
PERIODIC MAINTENANCE SERVICES > Engine CoolantINSPECTIONCAUTION:• Do not use water instead of coolant.• Refer to “RM” section for the recommended engine coolant. 1. Park the vehicle on a level surface.2. Make sure the engine coolant level in the reservoir tank is between & ...
Dtc b1407 met communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1407 MET COMMUNICATIONDTC DETECTING CONDITION:Communication failure between body integrated unit and combination meterCAUTION:When the combination meter is replaced, registration of the immobilizer system is r ...
Disassembly
CONTROL SYSTEMS > MT Gear Shift LeverDISASSEMBLY1. Remove the lock wires.(A)Lock wire2. Remove the rod from gear shift lever.(A)Rod(B)Lever(C)Stay3. Separate the rod and inner boot.4. Remove the snap ring from the stay.(A)Snap ring5. Separate the gear shift lever and the stay.6. Remove the boot a ...
