AIRBAG SYSTEM > Roll Connector
ADJUSTMENT
CAUTION:
• Do not rotate the roll connector to more than the specified number of turns. Otherwise, the roll connector internal wire may be broken.
• When determining the end stop, rotate the connector slowly without applying excessive force. Applying excessive force at the end stop may break the internal wire.
1. Check that front wheels are positioned in straight ahead direction.
2. Rotate the roll connector counterclockwise until it stops.
3. Rotate the roll connector clockwise approx. 2.5 turns until “
” marks are aligned.

Roll connector
RemovalShock sensors (dealer option)
The shock sensors trigger the alarm
system when they sense impacts applied
to the vehicle and when any of their
electric wires are cut. The alarm system
causes the horn to sound and the hazard
warning flashers to flash for a short time
when the sensed impact is weak, but it
warns of a strong ...
Replacement
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Gear OilREPLACEMENT1. Pull out the oil level gauge.2. Lift up the vehicle.3. Using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.CAUTION:• Immediately after the vehicle has been running or after idling f ...
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0451 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, ...