Subaru Crosstrek Service Manual: Active test Operation

Subaru Crosstrek Service Manual / Continuously variable transmission (diagnostics) / Active test Operation

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active Test

OPERATION

CAUTION:

• Be sure to perform the active test while the engine is not running.

• After executing the active test, execute the Clear Memory Mode.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Transmission Control System».

5. On «Select Function» display, select «Active Test».

Item	SSM display	Execution condition
Activating the actuator ON/OFF	F&R Clutch Solenoid	When all of the following conditions are met:

• P range

• Ignition switch is ON (engine stops)

• Battery voltage is 10.9 V or more

Secondary Solenoid

Primary Down Solenoid

Primary Up Solenoid

AWD Solenoid

Lock-Up Duty Solenoid

NOTE:

For detailed operation procedures, refer to “Application help”.

Waveform

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Transmission Control Module (TCM) I/O SignalWAVEFORM1. SENSOR2. SOLENOID ...

Basic diagnostic procedure Procedure

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK PRE-INSPECTION.1) Ask the customer when and how the trouble occurred using the interview ...

Other materials:

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyINSTALLATION1. Clean the mating surfaces of the transmission case, transfer case and extension case.2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the rolle ...

Read diagnostic trouble code (dtc) Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Selec ...

System operation
Operating conditions The BSD/RCTA system in the Subaru Ascent functions only when specific operating requirements are satisfied. These conditions ensure accurate detection and reliable system performance. The ignition switch of the Subaru Ascent is in the "ON" position. The BSD/ ...