Subaru Crosstrek Service Manual: Caution
INSTRUMENTATION/DRIVER INFO > General Description
CAUTION
• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting the battery ground cable. Otherwise, the memory is cleared.
• Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.
• Use gloves to avoid damage and getting fingerprints on the glass surface and meter surfaces.
• Do not apply an excessive force on the printed circuit.
• Do not drop or otherwise apply impact.
• Connect the connectors securely during reassembly.
• After reassembly, make sure that each component operates normally.
• When the combination meter assembly has been replaced, be sure to perform the following operations.
– For models without the keyless access with push button start except for C5, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL FOR IMMOBILIZER”.
– Be sure to reset the ODO fuel economy value of the multi-function display (MFD). (High grade type) Multi-function Display (MFD) System > OPERATION">
• Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions of “AIRBAG SYSTEM” in this case. General Description > CAUTION">
• Be careful not to damage the airbag system wiring harness when servicing electrical parts and switches.
• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
Specification
INSTRUMENTATION/DRIVER INFO > General DescriptionSPECIFICATION1. COMBINATION METER ASSEMBLYNOTE:Specifications of the combination meter vary depending on the market and the grade.• Model with ...
Other materials:
Basic diagnostic procedure Procedure
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• The power steering control module continues to operate after the engine stops and calculate the temperature in the control module. Therefore, before starting service of the power steering sys ...
Note
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemNOTEFor procedure of each component in the Multi-Function Display (MFD) system, refer to the respective section.• Multi-function display: Multi-function Display (MFD) > REMOVAL">• Multi-function display switc ...
Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...
