Subaru Crosstrek Service Manual: 32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code
32
This DTC is detected out of vehicle speed range.
Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.
If cancel code is still detected after setting cruise again, perform the diagnosis for DTC 22.
Refer to DTC 22 for diagnostic procedure.
Diagnostic Procedure with Cancel Code > 22">
31
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code31Engine speed signal malfunction is detected.Abnormal increase of engine speed is detected.Gear is placed in 1st or Rever ...
34
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code34The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise dr ...
Other materials:
Dtc b1695 door sensor lh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1695 DOOR SENSOR LH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front door impact sensor (LH) is faulty.If DTC AB is displayed, the circuit within the front door impact sensor (LH) i ...
Basic diagnostic procedure Procedure
BODY CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.• Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and ...
Installation
FRONT SUSPENSION > Front StrutINSTALLATION1. Install the strut mount - front at the upper side of the strut to the body, and tighten it with new flange nuts.Tightening torque:20 N·m (2.04 kgf-m, 14.8 ft-lb)2. Align alignment marks on the camber adjusting bolt and strut.Using new self-locki ...
