Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

3. Remove the glove box. Glove Box > REMOVAL">

4. Remove the center grille assembly. Air Vent Grille > REMOVAL">

5. Remove the audio assembly or navigation assembly. Audio > REMOVAL">

6. Remove the socket assembly.

(1) Disconnect the connector.

(2) While releasing the claw inside, press it in from the rear to remove the socket assembly.

(3) Remove the clip - socket.

Wiring diagram

Front speaker

Other materials:

Certification for the Hands-free system
This device complies with Part 15 of FCC Rules and Industry Canada's licenceexempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause u ...

Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main shaft spline• Contact surface of rele ...

Dtc b1642 side satellite sensor bus rh lost communication
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1642 SIDE SATELLITE SENSOR BUS RH LOST COMMUNICATIONDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (R ...