Subaru Crosstrek Service Manual: Installation

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

• Make sure the hoses do not interfere with each other or with other components.

• Check each hose for bent, excess curve, and twisting conditions.

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection

Cvtf filter

Other materials:

Operation
ENTERTAINMENT > Audio SystemOPERATION1. SUBARU STARLINK CONNECTION ID DISPLAYModel with 6.2 inch display1. Turn the ignition switch to ACC.2. Press the HOME button (a) to display the {HOME} screen.3. Touch the {SETTINGS} (b) to display the {SETTINGS} screen.4. Touch the {Settings General} (c) to ...

Dtc b2275 engine start request control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2275 ENGINE START REQUEST CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in engine start permission signal output circuit in the keyless access CM. ...

Screen OFF setting
1. Perform the preparation steps according to "Preparation for image quality and volume settings" 2. Operate the " " or "  " switch to select the "Screen Off" item. Then push the button. 3. Push the button once more. 4. The screen is turned off. Restoring the s ...