Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Voice command example: Dial number

1. Press the talk switch on the steering wheel.

2. Say "Dial number".

3. Say "Dial <number>".

For example, if the phone number is 2345678: Say "two three four five six seven eight" Do not say "twenty three forty five sixty seven eight"

4. Say"Dial" or press the off hook switch on the steering wheel.

NOTE

When the system recognizes multiple phone numbers, a phone number candidate list will be displayed on the screen. Pressing the off hook switch on the steering wheel makes a call to the top entry on the list. If the desired phone number is not displayed on the top of the screen, say the number of the desired phone number from the candidate list to select a phone number from the candidate list.

Calling to the following phone numbers

As the system cannot recognize additional numbers, say the complete number without stopping.

Voice command example: Call name
1. Press the talk switch on the steering wheel. 2. Say "Call <contacts>" A confirmation screen will be displayed showing the recognition results. If multiple matching items are fou ...

Casual speech recognization
Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command. ...

Other materials:

Caution
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMThe airbag system wiring harness is routed near the keyless access with push button start system.CAUTION:• Do not use electrical test equipment on any wiring harnesses and connectors i ...

Dtc b1012 battery backup power supply
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1012 BATTERY BACKUP POWER SUPPLYDTC detecting condition:Voltage failure caused by poor contact of battery power supply backup circuitsTrouble symptom:Illuminations for the keyless entry, map light, lug ...

Basic inspection
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC INSPECTION1. VOLTAGE MEASUREMENT1. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal and the positive lead to the connector or component terminal.2. Contact the positive lead of the voltmeter on connect ...

© 2016-2026 Copyright www.sucross.com