Subaru Crosstrek Owners Manual: Remote transmitter program (models without "keyless access with push-button start system")
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to eight transmitters). New remote engine start transmitters can be programmed accord-ing to the following procedure.
1. Open the driver's door (the driver's door must remain opened throughout the entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to "ON" then "LOCK"/"OFF", back to "ON" then "LOCK"/ "OFF", back to "ON" then "LOCK"/"OFF", then back to "ON" again and leave the ignition "ON" throughout the programming process.
4. The system will flash the side marker lights, tail lights and parking lights and honk the horn three times, indicating that the system has entered the transmitter learn mode.
5. Press and release the " " button on the transmitter that you want to program.
6. The system will flash the side marker lights, tail lights and parking lights and honk the horn one time, indicating that the system has learned the transmitter. Upon successful programming, the remote start confirmation transmitter button will flash one time.
7. Repeat step 5 for any additional transmitters (the system will accept up to eight transmitters).
8. The system will exit the transmitter learn mode if the key is turned to the "LOCK"/"OFF" position, the door is closed or after 2 minutes.
Service mode (models without "keyless access with push-button start system")
In service mode, the remote engine start
function is temporarily disabled to prevent
the system from unexpectedly starting the
engine while being serviced.
To engage or disengage service mode:
...
System maintenance
NOTE
For models without "keyless access
with push-button start system":
In the event that the vehicle's battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
...
Other materials:
Inspection
LIGHTING SYSTEM > Rear Combination Light AssemblyINSPECTION1. Apply battery voltage between the connector terminals to check the lighting condition of the light.Terminal No.Inspection conditionsSpecification6 (+) — 3 (−)Apply battery voltage.Stop light on2 (+) — 3 (−)Tail (small) ...
Occupant detection system
The occupant detection system sensor is
installed under the seat upholstery and
monitors the physique and posture of the
front passenger. Using this information,
the occupant detection system determines
whether the front passenger's SRS frontal
airbag should be deployed or not.
If the front ...
Caution
GLASS/WINDOWS/MIRRORS > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting t ...
