Subaru Crosstrek Service Manual: Refrigerant recovery procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery Procedure
PROCEDURE
CAUTION:
• During operation, be sure to wear protective goggles and protective gloves.
• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system and recycle the gas.
• When recycling the discharged refrigerant, keep service cans on hand. Because the recovery rate with the recovery system is approx. 90%, service cans are necessary to charge the refrigerant.
• Follow the detailed operation procedure described in the operation manual attached to the refrigerant recovery system.
(1) | Manifold gauge | (4) | High pressure valve | (7) | High-pressure hose |
(2) | Low pressure valve | (5) | Low-pressure hose | (8) | Low-pressure side service port |
(3) | Center valve | (6) | Center manifold hose (vacuum pump and charge) | (9) | High-pressure side service port |
1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">
2. Turn the ignition switch to OFF.
3. Attach the manifold gauge set.
Preparation tool:
Manifold gauge set
(1) Check that all valves are fully closed.
(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle respectively.
CAUTION:
Confirm that the connections are secure.
(3) Connect the center hose to the refrigerant recovery system.
Preparation tool:
Refrigerant recovery system
4. Follow the operation manual attached to the refrigerant recovery system to collect the refrigerant.
Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install ...
Ignition(h4do)
...
Other materials:
Dtc u0416 invalid data received from vehicle dynamics control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEThis is detected when CAN data from VDC is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&qu ...
Inspection
WIPER AND WASHER SYSTEMS > Wiper BladeINSPECTION1. Check and clean the rubber assembly - wiper.CAUTION:• Do not use organic solvent-based cleaner when cleaning rubber parts in order to avoid rubber part deterioration.• Clean rubber parts using a soft cloth or paper towel dampened with ...
Specification
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlSPECIFICATION1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROLWhen the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.• When the speed of at least one wheel reaches ...
