Subaru Crosstrek Service Manual: Preparation tool
AIRBAG SYSTEM > General Description
PREPARATION TOOL
1. SPECIAL TOOL
• TEST HARNESS N
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299SA000
TEST HARNESS N
Used for unit inspection of steering roll connector.
• TEST HARNESS Q
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299SA040
TEST HARNESS Q
Used for unit inspection of steering roll connector.
• TEST HARNESS ADAPTER D
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299SA010
TEST HARNESS ADAPTER D
• Used for operation process of knee airbag module.
• Used for operation process of curtain airbag module.
• Used together with AIRBAG DEPLOYMENT TOOL. (98299PA030)
• TEST HARNESS ADAPTER AM
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299FJ000
TEST HARNESS ADAPTER AM
• Used for operation process of passenger’s airbag module.
• Used together with AIRBAG DEPLOYMENT TOOL. (98299PA030)
• TEST HARNESS ADAPTER K
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299FG010
TEST HARNESS ADAPTER K
• Used for operation process of side airbag module.
• Used together with AIRBAG DEPLOYMENT TOOL. (98299PA030)
• AIRBAG DEPLOYMENT TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
98299PA030
AIRBAG DEPLOYMENT TOOL
• Used for operation process of airbag module.
• Used together with each test harness adapter.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Steering wheel puller | Used for removing the steering wheel. |
TORX® T40 | Used for removing and installing the beam COMPL - steering. |
Circuit tester | Used for measuring resistance, voltage and current. |
Caution
AIRBAG SYSTEM > General DescriptionCAUTION1. BEFORE STARTING ALL WORKS• Before performing vehicle maintenance, turn the ignition switch to OFF and disconnect the negative terminal from batter ...
Component
AIRBAG SYSTEM > General DescriptionCOMPONENT(1)Front sub sensor RH(4)Airbag warning light (in combination meter)(7)Airbag control module(2)Front sub sensor LH(5)Airbag ON/OFF indicator light (MFD)( ...
Other materials:
Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...
BSD/RCTA approach indicator light/warning buzzer
When the BSD/RCTA system in the Subaru Ascent is active, it continuously monitors
adjacent lanes and surrounding areas to enhance driver awareness. The BSD/RCTA approach
indicator light provides a clear visual alert when another vehicle is detected traveling
in a neighboring lane. In addition, ...
Installation
ENTERTAINMENT > Front Accessory Power Supply SocketINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer ...
