Subaru Crosstrek Service Manual: Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AWD Warning Light Display
OPERATION
AWD light illuminates or blinks, when the AWD is in special control condition and AWD has malfunction.
• At normal condition
After turning the ignition switch to ON, illuminates for 2 seconds then goes off.
• When FF mode is selected
AWD light illuminates when the AWD ON/OFF switching function is set to “FF mode” with the ignition switch ON.
• When malfunction is detected
AWD light blinks at 2 Hz when any of the following malfunctions are detected with the ignition switch ON.
1. When tire with different diameter is installed, or air pressure of any of four wheels is excessively low.
2. When “Rear differential inspection mode” is judged as NG Rear Differential Inspection Mode">
(A) | Ignition switch condition | ||||
(1) | At normal condition | (2) | When FF mode is selected | (3) | When malfunction is detected |
If the AWD light does not illuminate, or illumination patterns are not as above, check the AWD light circuit. AWD Warning Light Display > INSPECTION">
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AWD Warning Light DisplayINSPECTIONDIAGNOSIS:• CAN communication is lost with the combination meter.• Combination meter malfunction&bu ...
Other materials:
Dtc p0756 shift solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0756 SHIFT SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor ...
Auto Vehicle Hold indicator light
CAUTION
If the Auto Vehicle Hold indicator light in your Subaru Ascent does not activate
after selecting "Auto Vehicle Hold (AVH)", this may indicate a potential issue with
the electronic parking brake system. In such cases, the system may not function
as intended, and it is recomme ...
Removal
BRAKE > Brake BoosterREMOVALCAUTION:• Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.• Before handling the airbag system components, always refer to “CAUTION” of “Gene ...
