Subaru Crosstrek Service Manual: Neutral position switch Note
CRUISE CONTROL SYSTEM > Neutral Position Switch
NOTE
For the operation procedures for neutral position switch, refer to “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harness">
Inhibitor switch Note
CRUISE CONTROL SYSTEM > Inhibitor SwitchNOTEFor the operation procedures for inhibitor switch, refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Inhibitor Switch"> ...
Stop light brake switch Note
CRUISE CONTROL SYSTEM > Stop Light & Brake SwitchNOTEFor the operation procedures for stop light and brake switch, refer to “BRAKE” section. Stop Light Switch"> ...
Other materials:
Installation
CONTROL SYSTEMS > Select LeverINSTALLATION1. Set the select lever assembly to the vehicle body.2. Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)3. Connect the harness connector.4. Install the harness ...
Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with the radar sensor is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Def ...
Inspection
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)INSPECTION1. MULTI-FUNCTION DISPLAY SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3 (UP)ENTER (DOWN)All OFF1 M? or more (UP)ONLess than 1 ?ENTERONA ...
