Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position Sensor

INSTALLATION

Install in the reverse order of removal.

NOTE:

• Use new O-rings.

• Apply engine oil to O-ring.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorREMOVAL1. INTAKE SIDE1. Disconnect the ground cable from battery.2. Remove the air intake duct. (RH side only) Air Intake Duct > RE ...

Crankshaft position sensor
...

Other materials:

Handling of radar sensors
Radar sensors The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper. CAUTION To ensure correct operation of the BSD/RCTA, observe the following precautions. Always keep the bumper surface near the radar sensors clean Do not affix any stickers o ...

Checking the fluid level
WARNING Never let clutch fluid contact your eyes because clutch fluid can be harmful to your eyes. If clutch fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable. CAUTION Clutch fluid ab ...

Dtc b1507 external air temperature open/short-circuit detection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1507 EXTERNAL AIR TEMPERATURE OPEN/SHORT-CIRCUIT DETECTIONDTC detecting condition:Open or short circuit in ambient sensorTrouble symptom:• Defective ambient temperature display• Def ...

© 2016-2026 Copyright www.sucross.com