Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control Valve
INSTALLATION
Install in the reverse order of removal.
NOTE:
Use new O-rings and gaskets.
Tightening torque:
22 N·m (2.2 kgf-m, 16.2 ft-lb)
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR Control ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) ...
Egr cooler
...
Other materials:
Component
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > General DescriptionCOMPONENT1. TORQUE CONVERTER ASSEMBLY AND CONVERTER CASE(1)Drive plate(13)Pitching stopper bracketTightening torque: N·m (kgf-m, ft-lb)(2)Reinforcement drive plate(14)O-ringT1:18 (1.8, 13.3)(3)Torque converter ASSY(15)Stud bolt ...
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Differential Gear OilADJUSTMENTNOTE:Immediately after removing the overflow drain plug, remaining gear oil (approx. 8 cc) may come out of the overflow pipe. This is not included in the specified amount. When removing the overflow drain plug, make sure t ...
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the "RES/SET" switch to the
"SET" side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accelerator
pedal.
NOTE
U.S.-spec. models
If t ...
