Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain Separator
INSTALLATION
The drain separator is installed to the leak check valve assembly. Refer to “Leak Check Valve Assembly” for installation procedure. Leak Check Valve Assembly > INSTALLATION">
Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorINSPECTION1. Check that the drain separator and drain separator bracket have no deformation, crack, or other damage.2. Check ...
Other materials:
Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the h ...
Rear wiring harness and rear gate cord Location
WIRING SYSTEM > Rear Wiring Harness and Rear Gate CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionR163C-4 Rear door switch RHR223C-2 Rear door switch LHR2510BlackC-2 Radar sensor LH (master)R266GrayC-5 Rear combination light RHR286GrayC-3 Rear combination light LHR293BlackD-2 Rear ...
Initialize
Items that have been set to your preference
can be initialized. To select an
initialization menu, operate the "
" or " "
switch as follows.
Preparation for initialization
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to show
the selection screen.
3. ...
