LAN SYSTEM (DIAGNOSTICS) > General Description
INSPECTION
1. INSPECTION WITHOUT USING CAN DIAGNOSTIC
Before performing diagnosis, check the following items that might affect troubles of each module.
1. Check the battery. Battery > INSPECTION">
2. Check the fuse condition.
Make sure that ampere of the fuse is setting value, and it is not blown out.
3. Check the connecting condition of harness and harness connector.
2. INSPECTION USING CAN DIAGNOSTIC
Before performing diagnostics, check the following item which might affect body integrated unit malfunctions.
1. Confirm settings of body integrated unit are corresponded to vehicle equipment. Registration Body Integrated Unit > OPERATION">
2. Make sure that the User Customizing of the body integrated unit matches the vehicle equipment. User Customizing > OPERATION">
3. Confirm “Factory initial setting” of body integrated unit registrations is set to “Market”.
Preparation toolDiagnostic procedure for subaru select monitor communication Communication for initializing impossible
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDiagnosis:Defective harness connectorTrouble symptom:Subaru Select Monitor communication failureCAUTION:Use the check board when measuring the TC ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector from the engine.• Struc ...
Removal
EXTERIOR/INTERIOR TRIM > Mud GuardREMOVAL1. Lift up the vehicle.2. Remove the wheels.3. Remove the screws and clips to remove the mud guard.(1)Under cover - front(2)Mud guard - front(3)Mud guard - rear ...