Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door Actuator
INSPECTION
1. CHECK LINK
1. Visually check the operation range of the link, and remove the foreign material if any.
2. Operate the air flow control dial or switch to check that the link operates normally.
3. If it does not operate normally as the result of inspection, check the motor - actuator mode.
2. CHECK ACTUATOR
1. Check the resistance between actuator terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard | Connector Sketch |
3 — 1 | Always | 80 — 100 ? |
3 — 2
3 — 5
3 — 6
2. Replace the motor - actuator mode if it is found defective as a result of inspection.
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in &ldq ...
Other materials:
Inspection
LIGHTING SYSTEM > Headlight BulbINSPECTION1. HALOGEN TYPECAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• Do not leave the light assembly - head without the bulb and cover - headlight for a long time. Dust, moisture, etc. entering the ...
Diagnostics with phenomenon Inspection
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonINSPECTION1. KEYLESS ACCESS LOCK/UNLOCK CANNOT BE PERFORMED FROM ANY OF THE DOORSCAUTION:• Check that there are no other registered access keys inside the vehicle.• Inspect LAN system according to ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...
