Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Torque Converter Assembly

INSPECTION

Check the protrusion of torque converter center (front boss) is not deformed or damaged.

Check the ring gear and exterior for break or damage.

Torque converter assembly
...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Torque Converter AssemblyREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Pull out ...

Other materials:

Specification
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionSPECIFICATIONItemSpecification or identificationABS wheel speed sensorABS wheel speed sensor gap (for reference)Front0.77 — 1.43 mm (0.030 — 0.056 in)Rear0.44 — 1.76 mm (0.017 — 0.069 in)Identifications of harness (symbol)FrontRHZ1LHZ2Re ...

Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive PlateINSTALLATION1. Temporarily install the drive plate and reinforcement drive plate.NOTE:Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.2. Set the ST.ST 498497300CRA ...

© 2016-2023 Copyright www.sucross.com