Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case
INSPECTION
• Check there is no leak of CVTF from the joint between extension case and transmission case.
• Check there is no damage or cracks on the extension case and other parts.
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseDISASSEMBLY1. Remove the dust cover from extension case.2. Remove the extension case oil seal from the extension case. Differential Side R ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseINSTALLATION1. Clean the mating surface of extension case and transmission case.2. Select the transfer drive gear shim. Reduction Drive Ge ...
Other materials:
Operating range for push-button start system
Antenna
Operating range
NOTE
If the access key is not detected
within the operating range of the antennas
inside the vehicle, the pushbutton
ignition switch and the engine
start cannot be operated.
Even when the access key is outside
the vehicle, if it is placed too close to
the ...
Relay and fuse
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
Blind Spot Detection/Rear Cross Traffi ...
Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...
