Subaru Crosstrek Owners Manual: High/low beam change (dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light "
" on
the combination
meter is also on.
To switch back to low beam, pull the lever back to the center position.
Sensor for the auto on/off headlights (if equipped)
The sensor is on the instrument panel as
shown in the illustration.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light correctly
...
Headlight flasher
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on fo ...
Other materials:
Read diagnostic trouble code (dtc) Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Selec ...
Dtc b2311 rear radar detect tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2311 REAR RADAR DETECT TCMDTC DETECTING CONDITION:Automatic transmission fails.TROUBLE SYMPTOM:• All functions of BSD/RCTA stop.• Fail icon is displayed in the com ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorREMOVAL1. Disconnect the ground cable from battery. Battery > REMOVAL">2. Remove the ambient sensor.(1) Disconnect the connector.(2) Release the claws, and then remove the ambient sensor from the bracket. ...
