Subaru Crosstrek Service Manual: Electrical component location Location
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Electrical Component Location
LOCATION
(1) | Engine control module (ECM) | (4) | Cruise indicator light and cruise set indicator light | (7) | Neutral position switch (MT model) |
(2) | Cruise control command switch | (5) | Transmission control module (TCM) (CVT model) | (8) | Clutch switch (MT model) |
(3) | Stop light and brake switch | (6) | Inhibitor switch (CVT model) |
Basic diagnostic procedure Procedure
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Before performing all diagnostics or cruise control diagnostics, always start the engine and make sure that ...
List of cancel code List
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > List of Cancel CodeLISTNOTE:• The cancel code is registered even when cancel is performed intentionally by the driver.• Cancel codes are cleared if ...
Other materials:
Inspection
SECURITY AND LOCKS > Keyless Access Indoor AntennaINSPECTION1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION">2. Disconnect the Subaru Select Monitor. Operate the touch sensor of the door outer hand ...
Note
EyeSight > EyeSight SystemNOTEFor procedure of each component in the EyeSight system, refer to the respective section.• Control module: Control Unit">NOTE:System control of the EyeSight is performed by each module. For procedure, refer to the following sections.– Engine control ...
Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Sele ...
