Subaru Crosstrek Owners Manual: Efficient cooling after parking in direct sunlight
After parking in direct sunlight, drive with the windows open for a few minutes to allow outside air to circulate into the heated interior. This results in quicker cooling by the air conditioner. Keep the windows closed during the operation of the air conditioner for maximum cooling efficiency.
Lubrication oil circulation in the refrigerant circuit
Operate the air conditioner compressor at a low engine speed (at idle or low driving speeds) a few minutes each month during the off-season to circulate its oil.
Checking air conditioning system before summer season
Check the air conditioner unit for refrigerant leaks, hose conditions, and proper operation each spring. Have the air conditioning system checked by your SUBARU dealer.
Cleaning ventilation grille
Front ventilation inlet grille
Always keep the front ventilation inlet grille
free of snow, leaves, or other obstructions
to ensure efficient heating and defrosting.
Since the condenser ...
Cooling and dehumidifying in high humidity and low temperature weather
conditions
Under certain weather conditions (high
relative humidity, low temperatures, etc.) a
small amount of water vapor emission
from the air outlets may be noticed. This
condition is normal and does not ...
Other materials:
Dtc p0842 transmission fluid pressure sensor/switch "a" circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0842 TRANSMISSION FLUID PRESSURE SENSOR/SWITCH "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Shift characteristics malfunctionCAUTION:U ...
Inspection
LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries ...
Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...
