Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: During driving

General precautions:

Precautions when driving under especially dangerous situations:

If driving through water, such as when crossing shallow streams:

Water entering the engine air intake or the exhaust pipe or water splashing onto electrical parts may damage your vehicle and may cause it to stall. Never drive through rushing water. Regardless of its depth, it can wash away the ground from under your tires, resulting in possible loss of traction and even vehicle rollover.

If you must rock the vehicle to free it from sand or mud, depress the accelerator pedal slightly and move the shift lever/ select lever back and forth between "1"/ "D" and "R" repeatedly. Do not race the engine. For the best possible traction, avoid spinning the wheels when trying to free the vehicle.

When the road surface is extremely slippery, you can obtain better traction by starting the vehicle with the transmission in 2nd than 1st (both for MTand CVT). For CVT models, refer to "Selection of manual mode" F7-26.

Before driving
Make certain that you and all of your passengers are wearing seatbelts. Carry some emergency equipment, such as a towing rope or chain, a shovel, wheel blocks, first aid kit and cell phone ...

After driving
Always check your brakes for effectiveness immediately after driving in sand, mud or water. Do this by driving slowly and stepping on the brake pedal. Repeat that process several times to d ...

Other materials:

Specification
DRIVE SHAFT SYSTEM > General DescriptionSPECIFICATION1. PROPELLER SHAFTPropeller shaft typeEDJFront propeller shaft joint-to-joint length: L1CVT675.5 mm (26.59 in)MT735.5 mm (28.96 in)Rear propeller shaft joint-to-joint length: L2723 mm (28.46 in)Outer diameter of tube:D163.5 mm (2.50 in)D257.5 m ...

Removal
COOLING(H4DO) > Water PumpREMOVAL1. WATER PUMP PULLEY1. Disconnect the ground cable from battery. NOTE">2. Remove the V-belt covers.3. Remove the V-belts. V-belt > REMOVAL">4. Remove the radiator main fan & fan motor assembly. Radiator Main Fan and Fan Motor > REMOVAL ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS ...

© 2016-2026 Copyright www.sucross.com