CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULE
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when CAN communication failure occurs with the combination meter.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from combination meter | Lost |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc p2764 torque converter clutch pressure control solenoid control circuit low
Dtc u0164 lost communication with hvac control moduleMeters and gauges
NOTE
Some meters and gauges in the Subaru Ascent instrument cluster utilize liquid
crystal displays. If you are wearing polarized sunglasses, visibility of certain
indicators may be reduced.
Speedometer
The Subaru Ascent speedometer provides a clear and precise display of the vehicle’s
cu ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector (A) from the tumble ...
Dtc c1241 rear left abs sensor circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1241 REAR LEFT ABS SENSOR CIRCUITDTC detecting condition:• Defective ABS wheel speed sensor (broken wire, input voltage too high)• Defective harness connectorTrouble symptom:&bul ...