Subaru Crosstrek Service Manual: Dtc b28a6 internal stereo camera communication 1
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B28A6 INTERNAL STEREO CAMERA COMMUNICATION 1
Detected when communication error occurs inside the stereo camera.
DTC DETECTING CONDITION:
Communication error occurs inside the stereo camera.
TROUBLE SYMPTOM:
All functions of EyeSight system do not operate.
| STEP | CHECK | YES | NO |
1.CHECK RESTARTING.
1) Turn the ignition switch to OFF.
2) Start the engine.
3) Read the DTC. Diagnostic Code(s) Display">
Is DTC displayed after restarting the engine?*1
Replace the stereo camera. Stereo Camera > REMOVAL">
Clear the memory, in which temporary communication failure occurs and complete the step. Clear Memory Mode">
*1: When malfunction is detected after restarting the engine, 0 is registered in IG counter. Other values can be regarded as DTCs detected in the past.
Dtc b28a5 engine torque limiter control prohibit
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBITDetected when abnormal data is transmitted from stereo camera to engi ...
Dtc b28a7 stereo camera recognition(target)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28A7 STEREO CAMERA RECOGNITION(TARGET)Detected when error occurs in the communication data inside the control mo ...
Other materials:
Safety precautions
WARNING
Always use the utmost care in
driving - overconfidence because
you are driving a vehicle with the
Vehicle Dynamics Control system
could easily lead to a serious accident.
CAUTION
Even if your vehicle is equipped
with Vehicle Dynamics Control
system, winter tires should be
used when ...
Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsS ...
Temperature A, B, C
The temperature grades are A (the
highest), B, and C, representing the
tire's resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled conditions
on a specified indoor laboratory
test wheel. Sustained high
temperature can cause the material
of the t ...
