Subaru Crosstrek Service Manual: Check list for interview Check

Subaru Crosstrek Service Manual / Lan system (diagnostics) / Check list for interview Check

LAN SYSTEM (DIAGNOSTICS) > Check List for Interview

CHECK

Inspect the following item about the vehicle’s state.

1. DISPLAY STATUS IN THE COMBINATION METER

Display status in the combination meter	Engine coolant temperature gauge display	OK / NG
	Fuel gauge display	OK / NG
	Tachometer display	OK / NG (0 rpm at idling etc.)
Display of other indicators	Malfunction indicator light	ON / Blink / OFF
	Sport indicator light (AT warning light)	ON / Blink / OFF
	ABS warning light	ON / Blink / OFF
	VDC warning light	ON / Blink / OFF
	Immobilizer indicator light	ON / Blink / OFF
	AT OIL TEMP warning light	ON / Blink / OFF
	Tire pressure warning light	ON / Blink / OFF
	Engine coolant temperature warning light	Blue light ON / Red light ON / Red light blinks / Blue and red lights blink
	CRUISE indicator	ON / Blink / OFF
	Shift indicator	OK / NG
	Fuel level warning light	ON / Blink / OFF
	Airbag warning light	ON / OFF
	VDC OFF indicator	ON / OFF
	Brake warning light	ON / OFF
	Headlight beam leveler indicator	ON / OFF

2. CONDITIONS UNDER WHICH TROUBLE OCCURS

Driving condition	At standstill (While idling)
	When the vehicle is running	Vehicle speed km/h (MPH)
	While accelerating	Acceleration km/h (MPH) to km/h (MPH)
	Decelerating (With braking)	Deceleration km/h (MPH) to km/h (MPH)
	Decelerating (Without braking)	Deceleration km/h (MPH) to km/h (MPH)
	Flat road Uphill Downhill Gravel road Bumpy road Snowy road
	Does it occur when operating any part? Operated part: TROUBLE SYMPTOM:
	Are there any other troubles occurred? From where: TROUBLE SYMPTOM:

Basic diagnostic procedure Procedure

LAN SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active t ...

Clear memory mode Operation

LAN SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed» ...

Other materials:

Installation
CONTROL SYSTEMS > MT Gear Shift LeverINSTALLATION1. Insert the gear shift lever from the room side.NOTE:Insert the rod and the stay, and then temporarily set them onto the transmission mount.2. Lift up the vehicle.3. Install the joint to the transmission and secure with a spring pin.(A)Joint(B)Sp ...

Component
WIPER AND WASHER SYSTEMS > General DescriptionCOMPONENT1. FRONT WIPER• Models without EyeSight(1)Motor ASSY - windshield wiper(6)Rubber ASSY - windshield wiper driverTightening torque: N·m (kgf-m, ft-lb)(2)Link ASSY - windshield wiper(7)Arm ASSY - windshield wiper assistorT1:5.5 (0.5 ...

Malfunction indicator light remains blinking
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT REMAINS BLINKINGDiagnosis:The delivery (test) mode fuse circuit is short-circuited to ground.Trouble symptom:Malfunction indicator light blinks when delivery (test) mode fuse is not connected.Wiring diagram:Engine ...