CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with Phenomenon
CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT
TROUBLE SYMPTOM:
Cruise control can be set, but the CRUISE indicator and SET indicator do not illuminate.
| STEP | CHECK | YES | NO |
1.CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT.
Check the combination meter. Combination Meter System > OPERATION">
Do the CRUISE & SET indicators illuminate?
Diagnostics with Phenomenon > CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT">Go to Step 2.
Replace the meter case assembly. Combination Meter">
2.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. Basic Diagnostic Procedure">
Is a DTC of the LAN system detected?
Perform the diagnosis according to DTC for LAN system.
Replace the ECM. Engine Control Module (ECM)">
Diagnostic procedure with phenomenonDisassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyDISASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL4. Using the ST, r ...
Certification for the Hands-free system
This device complies with Part 15 of FCC
Rules and Industry Canada's licenceexempt
RSSs. Operation is subject to
the following two conditions: (1) This
device may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause u ...
Procedure
DIFFERENTIALS > Rear Differential Inspection ModePROCEDURECAUTION:Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.1. Shift the select lever to “P” range.2. Apply the parking brake.3. Lift up the vehicle.WARNING:Lift up ...