Subaru Crosstrek Service Manual: Refrigerant recovery procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery Procedure
PROCEDURE
CAUTION:
• During operation, be sure to wear protective goggles and protective gloves.
• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system and recycle the gas.
• When recycling the discharged refrigerant, keep service cans on hand. Because the recovery rate with the recovery system is approx. 90%, service cans are necessary to charge the refrigerant.
• Follow the detailed operation procedure described in the operation manual attached to the refrigerant recovery system.
(1) | Manifold gauge | (4) | High pressure valve | (7) | High-pressure hose |
(2) | Low pressure valve | (5) | Low-pressure hose | (8) | Low-pressure side service port |
(3) | Center valve | (6) | Center manifold hose (vacuum pump and charge) | (9) | High-pressure side service port |
1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">
2. Turn the ignition switch to OFF.
3. Attach the manifold gauge set.
Preparation tool:
Manifold gauge set
(1) Check that all valves are fully closed.
(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle respectively.
CAUTION:
Confirm that the connections are secure.
(3) Connect the center hose to the refrigerant recovery system.
Preparation tool:
Refrigerant recovery system
4. Follow the operation manual attached to the refrigerant recovery system to collect the refrigerant.
Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install ...
Ignition(h4do)
...
Other materials:
Dtc u0164 lost communication with hvac control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0164 LOST COMMUNICATION WITH HVAC CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSI ...
Locking and unlocking
Release button
Mechanical key
While pressing the release button of the
access key, take out the mechanical key.
Lock or unlock the driver's door with the
mechanical key in the procedure described
in "Locking and unlocking from
the outside" F2-5.
NOTE
After locking or unlocking, ...
Dtc c1311 fr hold valve
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1311 FR HOLD VALVENOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 NORMAL C ...
