Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)
INSTALLATION
1. Install the CVTF cooler (with warmer feature) to the transmission.
Tightening torque:
23 N·m (2.3 kgf-m, 17.0 ft-lb)
2. Install the engine coolant inlet hose.
NOTE:
With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.
3. Install the CVTF inlet hose and CVTF outlet hose to transmission.
NOTE:
Use the new CVTF inlet hose and CVTF outlet hose.
4. Connect the engine coolant outlet hose.
5. Check installation condition of each hose.
• Make sure the hoses do not interfere with each other or with other components.
• Check each hose for bent, excess curve, and twisting conditions.
(A) | CVTF cooler inlet hose |
(B) | CVTF cooler outlet hose |
(C) | Engine coolant outlet hose |
(D) | Engine coolant inlet hose |
6. Install the engine hanger rear.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.
8. Connect the engine harness connectors, then install the harness connector bracket.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">
10. Connect the battery ground terminal.
11. Fill engine coolant. Engine Coolant > REPLACEMENT">
12. Adjust the CVTF level. CVTF > ADJUSTMENT">
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check tha ...
Cvtf filter
...
Other materials:
Disassembly
MECHANICAL(H4DO) > Cylinder HeadDISASSEMBLY1. Remove the chain cover securing bolt from the cylinder head LH.2. Remove the stud bolts from the cylinder head.3. Remove the valve collet, valve, valve spring retainer, valve spring and valve spring seat from the cylinder head RH.CAUTION:During work, ...
Triple meter setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
" switch to
select the "Triple Meter" item. Then push
the
button.
3. Select the setting location (left, center
or right) by operating the "
" or "
"
...
Dtc c2533 control module board temperature sensor
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2533 CONTROL MODULE BOARD TEMPERATURE SENSORTROUBLE SYMPTOM:The steering wheel operation feels heavy.NOTE:When this code is displayed, replace the power steering control module with ...
