Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)
INSTALLATION
1. Install the CVTF cooler (with warmer feature) to the transmission.
Tightening torque:
23 N·m (2.3 kgf-m, 17.0 ft-lb)
2. Install the engine coolant inlet hose.
NOTE:
With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.
3. Install the CVTF inlet hose and CVTF outlet hose to transmission.
NOTE:
Use the new CVTF inlet hose and CVTF outlet hose.
4. Connect the engine coolant outlet hose.
5. Check installation condition of each hose.
• Make sure the hoses do not interfere with each other or with other components.
• Check each hose for bent, excess curve, and twisting conditions.
(A) | CVTF cooler inlet hose |
(B) | CVTF cooler outlet hose |
(C) | Engine coolant outlet hose |
(D) | Engine coolant inlet hose |
6. Install the engine hanger rear.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.
8. Connect the engine harness connectors, then install the harness connector bracket.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">
10. Connect the battery ground terminal.
11. Fill engine coolant. Engine Coolant > REPLACEMENT">
12. Adjust the CVTF level. CVTF > ADJUSTMENT">
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check tha ...
Cvtf filter
...
Other materials:
Removal
SECURITY AND LOCKS > Starter Cut RelayREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait fo ...
Dtc b1825 short in side airbag lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1825 SHORT IN SIDE AIRBAG LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is shorted.• Side airbag module (LH) is faulty.• Airbag control ...
Dtc c0033 fl hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0033 FL HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
