Subaru Crosstrek Service Manual: Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)
INSTALLATION
1. Install the CVTF cooler (with warmer feature) to the transmission.
Tightening torque:
23 N·m (2.3 kgf-m, 17.0 ft-lb)
2. Install the engine coolant inlet hose.
NOTE:
With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.
3. Install the CVTF inlet hose and CVTF outlet hose to transmission.
NOTE:
Use the new CVTF inlet hose and CVTF outlet hose.
4. Connect the engine coolant outlet hose.
5. Check installation condition of each hose.
• Make sure the hoses do not interfere with each other or with other components.
• Check each hose for bent, excess curve, and twisting conditions.
(A) | CVTF cooler inlet hose |
(B) | CVTF cooler outlet hose |
(C) | Engine coolant outlet hose |
(D) | Engine coolant inlet hose |
6. Install the engine hanger rear.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.
8. Connect the engine harness connectors, then install the harness connector bracket.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">
10. Connect the battery ground terminal.
11. Fill engine coolant. Engine Coolant > REPLACEMENT">
12. Adjust the CVTF level. CVTF > ADJUSTMENT">
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check tha ...
Cvtf filter
...
Other materials:
Installation
ENTERTAINMENT > AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” of ...
Refrigerant recovery procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery ProcedurePROCEDURECAUTION:• During operation, be sure to wear protective goggles and protective gloves.• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system ...
Adjustment
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxADJUSTMENT1. GEARBOX BACKLASH ADJUSTMENT1. Remove the steering gearbox assembly. Electric Power Steering Gearbox > REMOVAL">2. Loosen the lock nut and adjusting screw.3. Apply a coat of grease to the sliding surfa ...
