Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Wiring diagram

Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O Signal

WIRING DIAGRAM

Refer to “BSD/RCTA System” in the wiring diagram. Blind Spot Detection/Rear Cross Traffic Alert > WIRING DIAGRAM">

System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.&bu ...

Diagnostic procedure with diagnostic trouble code (dtc)
...

Other materials:

Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">4. Remove the propeller shaft. Propeller Shaft > REMOVAL"& ...

Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsS ...

© 2016-2022 Copyright www.sucross.com