Subaru Crosstrek Service Manual: Wiring diagram
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Engine Control Module (ECM) I/O Signal
WIRING DIAGRAM
Refer to “Cruise Control System” in the wiring diagram. Cruise Control System > WIRING DIAGRAM">
Electrical specification
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Engine Control Module (ECM) I/O SignalELECTRICAL SPECIFICATIONFor details on the input/output signals for the engine control module, refer to ENGINE (DIAGNOSTI ...
Other materials:
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the "RES/SET" switch to the
"SET" side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accelerator
pedal.
NOTE
U.S.-spec. models
If t ...
Note
LIGHTING SYSTEM > Back-up Light SystemNOTEFor operation procedures of each component of the back-up light system, refer to the respective section.• Rear combination light assembly: Rear Combination Light Assembly">• Back-up light bulb: Back-up Light Bulb"> ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
