Subaru Crosstrek Service Manual: Wiring diagram
COMMUNICATION SYSTEM > Horn System
WIRING DIAGRAM
Refer to “Horn System” in the wiring diagram. Horn System > WIRING DIAGRAM">
Inspection
COMMUNICATION SYSTEM > Horn SystemINSPECTIONSymptomsInspection stepsHorn does not sound1. Check the fuse.2. Check the horn relay.3. Check the role connector.4. Check the horn switch.5. Check the ho ...
Note
COMMUNICATION SYSTEM > Horn SystemNOTEFor operation procedures of each component of the horn system, refer to the respective section.• Horn ASSY: Horn">• Horn switch: Horn Swi ...
Other materials:
Dtc p0616 starter relay "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0616 STARTER RELAY "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATI ...
Dtc u0122 lost communication with vehicle dynamics control module
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULENOTE:Refer to “LAN SYSTEM” for diagnostic procedure. Basic Diagnostic Procedure"> ...
Rear wiper
To turn the rear wiper on, turn the knob
switch upward.
To turn the wiper off, return the knob
switch to the " " position.
With the switch turned to the "
" position,
the rear wiper will operate intermittently
at intervals corresponding to the
vehicle speed. In this position, whe ...
