Subaru Crosstrek Owners Manual: Windshield wipers
Mist (for a single wipe)
Off
Intermitten
Low speed
High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to
the " 
" position.
For a single wipe of the wipers, push the lever up. The wipers operate until you release the lever.
Windshield wiper and washer switches
The wiper operates only when the ignition
switch is in the "ON" or "ACC" position. ...
Wiper intermittent time control
When the wiper switch is in the "
"
position, turn the dial to adjust the operating
interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval ...
Other materials:
Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...
Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» ...
Dtc b1831 open in curtain airbag rh squib circuit
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1831 OPEN IN CURTAIN AIRBAG RH SQUIB CIRCUITDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is open.• Curtain airbag module (RH) is faulty.&bul ...
