1) Metal support
1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the metal support.
1) Metal spines
2. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and install them in the new blade rubber.
3. Align the claws of the metal support with the grooves in the rubber and slide the blade rubber assembly into the metal support until it locks.
1) Stopper
4. Be sure to position the claws at the end of the metal support between the stoppers on the rubber as shown. If the rubber is not retained properly, the wiper blade may scratch the windshield.
Dtc p0420 catalyst system efficiency below threshold bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0420 CATALYST SYSTEM EFFICIENCY BELOW THRESHOLD BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Idle mixture is out of s ...
Assembly
REAR SUSPENSION > Rear Shock AbsorberASSEMBLY1. Before assembly, check each part. Rear Shock Absorber > INSPECTION">2. Using a coil spring compressor, compress the coil spring - rear.CAUTION:When installing the coil spring compressor to the coil spring, follow the operation manual acc ...
Note
LIGHTING SYSTEM > Back-up Light SystemNOTEFor operation procedures of each component of the back-up light system, refer to the respective section.• Rear combination light assembly: Rear Combination Light Assembly">• Back-up light bulb: Back-up Light Bulb"> ...