Subaru Crosstrek Owners Manual: Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by holding its pivot area and pushing it in the direction shown by the arrow while depressing the wiper blade stopper.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
4. Hold the wiper arm by hand and slowly lower it in position.
Replacement of wiper blades
Grease, wax, insects, or other material on
the windshield or the wiper blade results in
jerky wiper operation and streaking on the
glass. If you cannot remove the streaks
after operating the winds ...
Windshield wiper blade rubber
1) Metal support
1. Grasp the locked end of the blade
rubber assembly and pull it firmly until the
stoppers on the rubber are free of the
metal support.
1) Metal spines
2. If the new bla ...
Other materials:
Inspection
SECURITY AND LOCKS > ReceiverINSPECTION1. Check if the door lock operates when the touch sensor of the door outer handle and rear lock button is operated.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS A ...
Disabling keyless access function
WARNING
If you wear an implanted pacemaker
or an implanted defibrillator, perform
the procedure described in
"By operating the driver's door"
2-18 to disable the keyless access
function. If you perform the procedure
described in "By operating the
access key" 2-18, the operation of
an implan ...
Removal
COOLING(H4DO) > Radiator Sub Fan and Fan MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector from the sub fan motor assembly.4. Remove the bolts which hold the radiator sub fan sh ...