Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Windshield washer fluid

Use windshield washer fluid. If windshield washer fluid is unavailable use clean water.

In areas where water freezes in winter, use an anti-freeze type windshield washer fluid. SUBARU Windshield Washer Fluid contains 58.5% methyl alcohol and 41.5% surfactant, by volume. Its freezing temperature varies according to how much it is diluted, as indicated in the following table.

In order to prevent freezing of washer fluid, check the freezing temperatures in the table above when adjusting the fluid concentration to the outside temperature.

If you fill the reservoir tank with a fluid with a different concentration from the one used previously, purge the old fluid from the piping between the reservoir tank and washer nozzles by operating the washer for a certain period of time. Otherwise, if the concentration of the fluid remaining in the piping is too low for the outside temperature, it may freeze and block the nozzles.

CAUTION

Adding the windshield washer fluid
CAUTION Never use engine coolant as washer fluid because it could cause paint damage. Remove the washer tank filler cap, then add windshield washer fluid until it reaches the "FULL" mark on ...

Replacement of wiper blades
Grease, wax, insects, or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the winds ...

Other materials:

Parking in cold weather
WARNING Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle if you park the vehicle in snow with the engine running. CAUTION Do not use the parking brake when parking for long periods in cold weather since it could free ...

Birthday setting
1. Perform the preparation steps according to "Preparation for date setting" 3- 56. 2. Operate the " " or " " switch to select the "Birthday" item. Then push the button. 3. Select an entry in the list to set by operating the "  " or " " switch. Then push the ...

Inspection
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSPECTION1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ignition switch to ON. (Engine OFF)3. Measure the voltage between ECM connector terminals.• Main ...

© 2016-2026 Copyright www.sucross.com