Subaru Crosstrek Service Manual: Wheel bearing Inspection

1. FRONT WHEEL BEARING

NOTE:

Inspect the condition of front wheel bearing grease.

1. Jack-up the front side of vehicle.

2. While holding the front wheel by hand, swing it in and out to check bearing free play.

3. Loosen the wheel nuts, and remove the front wheel.

4. If the bearing free play exists in step 2) above, attach a dial gauge to the hub and measure axial play in axial direction.

Service limit:

Straight-ahead position within 0.05 mm (0.0020 in)

5. Remove the bolts and self-locking nuts, and extract the front arm from front crossmember.

6. Remove the joint of front drive shaft from transmission. Front Axle">

7. While supporting the front drive shaft horizontally with one hand, turn the hub with the other hand to check for noise or binding.

If the hub is noisy or binds, replace the front axle.

1. Jack-up the rear side of vehicle.

2. While holding the rear wheel by hand, swing it in and out to check bearing free play.

3. Loosen the wheel nuts, and remove the rear wheel.

4. If the bearing free play exists in step 2) above, attach a dial gauge to the hub and measure axial play in axial direction.

Service limit:

Straight-ahead position within 0.05 mm (0.0020 in)

5. Remove the joint of rear drive shaft from rear differential. Rear Drive Shaft">

6. While supporting rear drive shaft horizontally with one hand, turn the hub with the other hand to check for noise or binding.

If the hub is noisy or binds, replace the rear axle.

Tire inspection and rotation Inspection

Power assisted system (power steering) (diagnostics)

Other materials:

Dtc c0051 valve relay
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0051 VALVE RELAYDTC detecting condition:Defective valve relayTrouble symptom:• ABS does not operate.• EBD does not operate.• VDC does not operate.• EyeSight does not ...

Assembly
GLASS/WINDOWS/MIRRORS > Outer Mirror AssemblyASSEMBLYCAUTION:• Be careful not to catch the harness in between the parts.• When installing the mirror - repair, insert the connector and clip securely.1. Install the light assembly - side turn mirror.2. Install the cover - cap outer mirro ...

Dtc b2277 submerging circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2277 SUBMERGING CIRCUITDTC detecting condition:When the water-submersion detection circuit integrated into the keyless access CM detects the water submersion.Trouble symptom:&b ...