Subaru Crosstrek Owners Manual: Voice command example: Call
name
1. Press the talk switch on the steering
wheel.
2. Say "Call <contacts>"
NOTE
- In the same manner as it is displayed
on the screen, "Call <contacts>",
after saying "Call a contact"
say the name of a contact. For example:
"Call a contact", "John Smith" or
"Call a contact", "Mary Davis"
- Short or abbreviated names in the
contacts list may not be recognized.
Change names in the contacts list to
full names.
- Sometimes a voice recognition result
confirmation screen will be displayed.
After confirming the result, say "Yes" or "No".
- When the system recognizes multiple
names from the contacts list, a
name candidate list will be displayed
on the screen. If the desired name is
not displayed on the top of the screen,
say or select the number of the name
from the candidate list (number 1,
number 2, etc.) to select a name from
the candidate list.
- When a contact has multiple phone
numbers registered in the contacts list,
a candidate list will be displayed. If the
desired phone number is not displayed
on the top of the screen, say or select
the number of the desired phone
number from the candidate list (number
1, number 2, etc.) to select a phone
number from the candidate list.
1. Press the talk switch on the steering
wheel.
After the voice command top screen has
been displayed, speech guidance will
commence.
NOTE
When the voice command mode is
audio mode, voice ...
1. Press the talk switch on the steering
wheel.
2. Say "Dial number".
3. Say "Dial <number>".
For example, if the phone number is
2345678:
Say "two three four five six seven
eight"
...
Other materials:
By incoming calls
On the phone (menu) screen, select the
"Incoming Calls" key to open the "Incoming
Calls" screen.
You can make a call by selecting an item
in the incoming call history list.
If there is no incoming call history, a
message appears to indicate that there
is no incoming call history data.
...
Inspection
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing the diagnosis, check the following items which may cause problems relating the wiper or light.1. Check the battery. Battery">2. Check the fuse condition.3. Check the connecting condition of harness ...
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the front wheels.3. Remove the front ABS wheel speed sensor.CAUTION:• Be careful not to damage the sensor.• Do not ap ...
© 2016-2024 Copyright www.sucross.com