Subaru Crosstrek Owners Manual: Vehicle Dynamics Control OFF indicator light
The
light illuminates when the Vehicle
Dynamics Control OFF switch is pressed
to deactivate the Vehicle Dynamics Control
system.
The Vehicle Dynamics Control system is probably malfunctioning under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately.
- The light does not illuminate when the ignition switch is turned to the "ON" position.
- The light does not turn off even once several seconds have elapsed after the ignition switch has been turned to the "ON" position.
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
The light may remain illuminated for
a short perio ...
Warning chimes and warning indicator of the keyless access with push-button
start system (if equipped)
Access key warning indicator (type A)
Access key warning indicator (type B)
The warning chime and the access key
warning indicator are used for the following
purposes.
Minimizing impro ...
Other materials:
Dtc b28a1 eyesight communication(ecm)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28A1 EyeSight COMMUNICATION(ECM)Detected when the engine control module (ECM) detects the malfunction of stereo camera, or when the stereo camera or ECM is assembled incorrectly.DTC DETECTING CONDITION:• De ...
Dtc p0711 transmission fluid temperature sensor "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0711 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:&b ...
Electrical specification
LAN SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Body integrated unitFor I/O signals of the body integrated unit, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). Control Module I/O Signal">• Engine CMFor I/O signals of ECM, refer to ENGINE (DIAGNOSTIC ...
